Our latest feature article explains the importance of case neck uniformity and reviews the best tools for measuring case neck thickness. But having uniform case neck walls is only part of the accuracy equation. You also want your cases to exhibit minimal run-out, as measured by a precision tool. For this reason, a quality concentricity gauge belongs on your loading bench if you are looking for the nth degree of accuracy.
We’ve worked with quite a few concentricity gauges. They all have their strengths and weaknesses, but some just didn’t perform well at all with very short cases like the 6BR and 6PPC. One of our regular readers suggested we check out the H&H Concentricity Gauge, made by Bill Herron in Oregon. So far we are very impressed. A 6BR or PPC case doesn’t tip or rock, causing the needle to jump. We were able to get good, repeatable readings off a seated bullet, which wasn’t easy at all with some of the other units. Our friend agreed with our positive assessment of the H&H, saying: “I have four concentricity gauges. Among these tools, the H&H is the least expensive and the easiest to use of those designed for loaded round measurement AND bullet straightening. It is also built like a brick. However, the Sinclair is [probably] the best for looking at the case alone due to the bearing balls and their adjustability.”
The H&H uses an indicator block to eliminate off-center indicator readings. It will accept .22 PPC through .375 length cases. A reversible spindle acts as a pilot for checking neck thickness. Bill Herron says the unit can also re-align bullets, but we didn’t try out that capability. For more info, visit the H&H Industries website, or call Bill at (541) 327-1411.
In the current edition of 
